So now we have R1 left to add to our OSPFv3 Circus, so lets get to work configuring. A couple thing to mention, that OSPFv3 still needs neighbor statements, but I don't quite remember where its config'd or what the syntax is so lets gets started: R1#conf t Enter configuration commands, one per line. End … Continue reading Part 2: IPv6 / OSPFv3 configuration on Hub in NBMA, Hub stuck with neighbors in “ATTEMPT/DROTHER” state
We have a lot to accomplish, but first since I did a "wr er" like a nerd I have to reconfigure all the IP addresses again (as you see in the Topology I changed them to make them a bit more intuitive). One thing I wanted to point out while configuring this whole lab (and … Continue reading Part 1: Configuration of this new Topology in IPv6
(Added interface #'s to the Topology as we increase working with both IP's and interfaces) I wanted to touch this quick before moving on to policy routing, whether Distribute-Lists can block certain networks from a Summary Route, or if it's possibly at all. So I'll run through it quick here to move on: Distribute-List … Continue reading Part 4: The right ACL for the right job (Distribute-List vs Route-Map), Configuring 3-way Route Redistribution with a lot of failures but final success!!!
Still working with the same Topology seen above, I want to round off the Policy Routing videos to see if I can bring that into some scenario or freestyle lab, and see how crazy one can get with Policy Routing. The first thing to note that I have amazingly not known at all until this … Continue reading The extended traceroute command, and Local Policy Routing Configuration!