Python3 Network Programming – Deploying base NTP / Logging across entire network, best practices, and the raw script at the very end of the post!

To round off the Netmiko section of Python3, I'd like to show a script that will standardize the entire network here with NTP and Buffered Logging, as those two things should be absolutely configured on a network for troubleshooting purposes. The configs shown are very minimal, and definitely not best practice for production networks, which … Continue reading Python3 Network Programming – Deploying base NTP / Logging across entire network, best practices, and the raw script at the very end of the post!

Python3 Network Programming – Writing a script that calls a file to use within the script (and a lot of troubleshooting the script itself)!

Finally the power to Automate Network Device Standardization!!! In this demo I will actually be starting small, adding SW4 and SW5 to write a script similar to the last lab, only instead of sending config line by line, it will open a file on the NetAuto Host that will contain configs to be written. This … Continue reading Python3 Network Programming – Writing a script that calls a file to use within the script (and a lot of troubleshooting the script itself)!